This Waterway Executive wet end is complete (it even has the wet end seal inside), and just needs to be connected to a motor.
This wet end is compatible with the various 56-Frame motors used in the Waterway Executive Euro range, both single-speed and 2-speed.
The wet end is available with a choice of four different impellers, which are confusingly called 2 HP, 3 HP, 4 HP and 5 HP. Be careful: the names correspond to the American versions of these pumps. The correct turbine will indicate a higher power rating than your pump motor! To choose the right model, look for a reference on your old wet end or impeller, not on the motor. If in doubt, we recommend the 3 HP version for a motor under 1500W, 4 HP for a motor between 1500 and 1800W, and 5 HP for a motor over 1800W. If you're still in doubt, feel free to contact us.
Width: 204 mm
Height: 214 mm
Distance between connecting bolts on rear: 147 mm diagonal, 104 mm orthogonal, making this wet end compatible with 56-Frame motors (single-speed or two-speed).
Two sizes of suction are available: the screw thread can have an outside diameter of either 78 mm or 94 mm.
Waterway part numbers
Complete wet end: 310-1440, 310-1480, 310-1500, 310-1510, 310-1720, 310-1730, 310-1740 or 310-1750, depending on the configuration.
Volute: 315-1220 (if you find this code on the back of your current wet end then you have definitely found the right part!)
Flaceplate: 311-1220 (78 mm) or 311-1210 (94 mm)
5 HP impeller: 310-4180
4 HP impeller: 310-4190
3 HP impeller: 310-4200
2 HP impeller: 310-4210
Wet end seal: 319-3100B
All these parts are also available separately - please contact us for more information.