Cord and AMP plug for 2-speed pumps

18,00€
In stock
18,00€
Cable length
Quantity:  
Cord and AMP plug for 2-speed pumps - Click to enlarge
Cord and AMP plug for 2-speed pumps - Click to enlarge

This cord connects a 2-speed pump to a control system by an AMP plug. Just connect the 4 wires (2 lives - one for each pump speed - neutral and earth) to the pump, and plug the AMP plug directly into the control system. The cable insulation is designed for long-term use in spas, and is resistant to heat and humidity.

Three cable lengths are available, approximately 48" or 120 cm, 72" or 180 cm, and 96" or 240 cm.

This cord is useful if you need to convert from mini-J&J to AMP plugs after upgrading your control system, for example.

Electrical characteristics
Cross section of conductor: 2.08 mm² (AWG 14)
Maximum current: 16A
Maximum power: 3700W