Aqua-Flo Flo-Master XP2e impeller

This impeller is used exclusively by the Aqua-Flo XP2e pump (available in single-speed and two-speed models). Five versions of the impeller are available, and you can usually tell which is which by the small colored dots on its shaft.

We strongly suggest that you replace the wet end seal at the same time as the impeller.

Careful: this impeller is not used on any other model of pump. We also have the impeller for the XP2 (without the e) pump.

Dimensions : see diagrams
Outside diameter of the shaft: 16 mm
Outside insertion diameter of the wear ring: 60 mm

Part numbers
1.5 HP: 91695150 - two dots: silver and yellow
2.0 HP: 91695200 - two dots: silver and blue
2.5 HP: 91695250 - two dots: silver and white
3.0 HP: 91695310 - two silver dots
4,0 HP: 91695400 - two dots : silver and green (discontinued)
4,0 HP: 91695401 - three dots: silver, green and green
5,0 HP: 91695500 - one silver dot