3/8" ribbed barb air-bleed adapter

5,00€
In stock
5,00€
Quantity:  
3/8" ribbed barb air-bleed adapter - Click to enlarge
3/8" ribbed barb air-bleed adapter - Click to enlarge
3/8" ribbed barb air-bleed adapter - Click to enlarge

This adapter from 1/4-inch MPT to 3/8-inch ribbed barb is often used in air-bleed valves and pump drain valves.

The threaded end can be screwed into the drainage point (it can replace a drain plug) on the wet end of most Waterway and Aqua-Flo pumps, among others, and this part is sometimes used to connect a 3/8-inch pipe to help prime the pump.

Remember to change the o-ring at the same time as the adapter to guarantee proper sealing.

Please note: we recommend screwing in the adapter with a wrench, its thread being a little bit bigger than some drain plugs, but still suitable for replacement.

An Inox version is available in the same size, as well as a similar adapter but for 1/4-inch pipes.

Compatible pumps
Waterway Iron Might, Executive single-speed and two-speed, Viper, Hi-Flo single-speed et two-speed
Aqua-Flo Flo-Master XP2, XP2e single and two-speed
Some Balboa and HydroAir pumps
LX Whilpool new models (made since 2018)

Dimensions
External diameter of the threaded side: 13 mm or 1/4-inch MPT
External diameter of the push-fit side : 10,5 mm

Part numbers
Waterway: 672-4350
Beachcomber: AJL-851-0210


You may also be interested in these products

 1,50€ 
In stock
 3,00€ 
Less than 1 week
 23,70€ 
In stock