HydroQuip vertical low-flow 3 kW heater, reconditioned

This reconditioned low-flow vertical heater from HydroQuip is in very good condition and has a power rating of 3 kW. It is used by Vita Spa and Maax Spas in particular, but it is also compatible with many other brands.

It can replace Therm Products' E2280-0300ET and E2300 Saratoga heaters, which are no longer on the market.

In addition to its replaceable titanium element, this heater is also supplied with an heat indicator light, a manual Hi-Limit trip reset button, an adjustable sensor clip and a reversible foot bracket.

The sensors and pressure switch are not included.

This heater requires a minimum consistent water flow rate of 6 gallons per minute (or 22 liters per minute).

It is supplied with fitting (ring, union and gasket) for 1-inch pipes.

Please note that the heater is delivered without a power cable (AMP plug) and without a set of 4 screws to secure the heater to the floor. We advise you to re-use these components from your old heater, or to us.

Dimensions
Height: 310 mm
Max. width (with mounting brackets): 148 mm

Technical specifications
Power: 3 kW
Current: 12.5 A

Connections
Outer diameter of both fittings: 28 mm or 1-inch M+, for 1-inch pipes

Warranty
6-month Tubs Parts warranty

Part numbers
HydroQuip: 27-V310-4T-K
Installation kit: 48-0310-K
Can replace, with sometimes installation adaptations, the Therm Products heaters with the following references: E2300-0012, E2300-0127ETX, E2300-0127ET, E2300-0127ET, E2300-0126ET, E2300-0321, E2300-0321 AND, E2300-0542ET, 20-00542, 26-08116