HydroQuip 1.5 kW No-Fault heater for Hot Spring

In stock
519,00€
incl. 20% VAT
Quantity:  
HydroQuip 1.5 kW No-Fault heater for Hot Spring - Click to enlarge
HydroQuip 1.5 kW No-Fault heater for Hot Spring - Click to enlarge
HydroQuip 1.5 kW No-Fault heater for Hot Spring - Click to enlarge

The Watkins "No Fault" heater is manufactured in the USA by HydroQuip, and is found on Hot Spring hot tubs. Its Titanium element delivers 1.5 kW of heating power. It connects to 3/4" flexible pipe.

The sensors at the inflow and the outflow of the heater are included, as well as:

  • two plug adaptors for use with IQ2000 (Years 1995-2002)
  • a small 3/4 inch hose to extend the water hose if necessary
  • a small 3/8 inch hose, a coupler and two clamps to extend the air purge hose if necessary (if you don't use it, a plug is available)

You can also buy the temperature and, Hi-Limit sensors separately, if needed, or replace the pair.

Some older versions of this heater have a built-in pressure switch, and a little control cable that connects to the motherboard of the hot tub control system, to tell the system that there is water flowing through the heater. If you are replacing a heater of this type, you should plug in a jumper, in place of the pressure switch cable, on the motherboard.

The barb replacement kit, turn-around kit and replacement o-rings for the sensors are available as spare parts.

We also offer the 3 kW version of this heater, which can be installed on Hot Spring, Tiger River and Caldera spas, among others.

Warranty
2-year Tubs Parts warranty

Part numbers
Watkins: 73796, 73792
ThermProducts: C3182-1, C3564-3
HydroQuip: 26-C3182-1S, 26-C3564-3


Parts related to the Watkins No-Fault 1.5 kW heater: